Setting-Up; Supplying Power To The V; Eloci Calc Plus; Installing The Batteries - TSI Instruments VelociCalc Plus 8384 Operation And Service Manual

Chapter 2

Setting-up

Supplying Power to the V

The V C
ELOCI ALC
batteries or the optional AC adapter.

Installing the Batteries

Insert four AA batteries as indicated by the diagram located on the
inside of the battery compartment. The V
to operate with either alkaline or NiCd rechargeable batteries. Battery
life will be shorter if NiCd batteries are used. Carbon-zinc batteries are
not recommended because of the danger of battery acid leakage.
Table 2-1 Typical Battery Life at 20°C
(ft/min)
100
5000

Using the Optional AC Adapter

When using the AC adapter, the batteries (if installed) will be bypassed.
The AC adapter is not a battery charger.

Selecting the Display Units

The V C
ELOCI ALC
several different measurement units. To change the display units on your
V C Plus, refer to Appendix B, DIP Switch Settings.
ELOCI ALC

Using The Telescoping Probe

The telescoping probe contains the velocity, temperature, and humidity
sensors (humidity sensor, Models 8386 and 8386A only). The probe can be
used either mounted to the V
probe is to be used mounted to the V
upward in the probe mounting brackets. When using the probe, make sure
the sensor window is fully exposed and the orientation dimple is facing
upstream.
ELOCI
Plus can be powered in one of two ways: four size AA
Air Velocity
(m/s)
0.5
25.0
Plus is capable of displaying the measured values in
ELOCI
C Plus
ALC
ELOCI
Alkaline
(hrs)
>8.0
5.0
C Plus or held in your hand. If the
ALC
C Plus, install it pointing
ELOCI ALC
C Plus is designed
ALC
3