Next Test (Clear) Key; Statistics (Review Data) Key; To View Statistics; To Review Data - TSI Instruments VelociCalc Plus 8384 Operation And Service Manual

NEXT TEST (clear) Key

Press to advance to the next test ID. If the current test ID does not have
anything stored, it will not advance to the next test ID. To clear the last
sample, press and hold the key and the display will begin a countdown from
5 to 0. Release the key at any time during the countdown before zero is
displayed. To clear all memory, keep holding key during the countdown.
Release the key when 0 is displayed. The display will flash 'CLEAR LOG'.
NOTE: Only the last sample recorded can be cleared without clearing the
entire memory. You cannot go back to a previous test ID and clear a single
reading. Also, you cannot add data to a previous test ID. Sample clear
does not work in continuous data logging mode.

STATISTICS (review data) Key

The STATISTICS key has two purposes. One is to view the statistics for the
currently displayed parameter and the other is review data for a particular
test ID.

To View Statistics

Press STATISTICS to view statistics for the parameter currently shown
on the large digits. The count will be shown on the small digits and the
test ID on the large digits. Count will stay on the small digits and the
large digits will change to displaying average. Press STATISTICS again
(before the average disappears from the display) to proceed to
maximum and again to display minimum.

To Review Data

Press and hold STATISTICS. The V
release the key and the test ID number will be displayed on the small
digits and the TEST ID symbol will light up. Use
desired test ID. Press ENTER to accept the test ID number. Use
select and view average, maximum, minimum, count, and individual
sample numbers with values for the selected test ID. The samples will
be displayed in the order that they were taken, from the first sample of
that test ID to the last. To view a different test ID, press STATISTICS
again to return to test ID on small digits and nothing on large digits.
to choose a new test ID, then press ENTER to accept the choice
Use
and continue as above to review the data. To review data of a different
measurement type, press the desired measurement type button while
AVG, MAX, MIN, COUNT or sample is being displayed. If there is no
data for that measurement type, "----" will be displayed. Press another
measurement type key to view more data or press ENTER to return to
measuring mode.
Operation
C Plus will beep twice,
ELOCI ALC
to select the
to
13