Do you have a question about the E1 and is the answer not in the manual?
Questions and answers
Jan Vera
January 18, 2025
Why does an E1 Pro inside camera ping all the time. FCC ID:- 2AL7V-E1PRO.
1 comments:
Mr. Anderson
May 14, 2025
The Reolink E1 Pro camera pings continuously after a reset if it is not properly reconfigured. After resetting, it needs to go through the installation process again. If not set up correctly, it may remain in a state where it emits continuous beeping sounds.
This answer is automatically generated
Dar
March 13, 2025
Lens will not rotate up after trying to input sd card. Cannot rotate lens up now to remove sd card. Please advise what is my next step
1 comments:
Mr. Anderson
March 13, 2025
If the lens on your Reolink E1 Pro camera will not rotate up to remove the SD card, it may be obstructed by the SD card itself. Try the following steps:
1. Check for Obstructions – Ensure that nothing is physically blocking the lens from rotating upward. 2. Restart the Camera – Power off the camera and turn it back on to see if the issue resolves itself. 3. Manually Adjust – Gently try to move the lens upward if it is stuck, but avoid applying excessive force. 4. Reset the Camera – If the issue persists, perform a factory reset to restore default settings. 5. Contact Support – If none of the above steps work, consider reaching out to Reolink support for further assistance.
These steps may help free the lens and allow access to the SD card.
Need help?
Do you have a question about the E1 and is the answer not in the manual?
Questions and answers
Why does an E1 Pro inside camera ping all the time. FCC ID:- 2AL7V-E1PRO.
The Reolink E1 Pro camera pings continuously after a reset if it is not properly reconfigured. After resetting, it needs to go through the installation process again. If not set up correctly, it may remain in a state where it emits continuous beeping sounds.
This answer is automatically generated
Lens will not rotate up after trying to input sd card. Cannot rotate lens up now to remove sd card. Please advise what is my next step
If the lens on your Reolink E1 Pro camera will not rotate up to remove the SD card, it may be obstructed by the SD card itself. Try the following steps:
1. Check for Obstructions – Ensure that nothing is physically blocking the lens from rotating upward.
2. Restart the Camera – Power off the camera and turn it back on to see if the issue resolves itself.
3. Manually Adjust – Gently try to move the lens upward if it is stuck, but avoid applying excessive force.
4. Reset the Camera – If the issue persists, perform a factory reset to restore default settings.
5. Contact Support – If none of the above steps work, consider reaching out to Reolink support for further assistance.
These steps may help free the lens and allow access to the SD card.
This answer is automatically generated