Adding Devices; Electronic Cylindrical Lock - ABB AccessControl System Manual

3.2

Adding devices

3.2.1

"Electronic cylindrical lock"

Attention! - Damage to the electronics
When touching electronic components they can be damaged by the electrostatic
discharge of a person.
–
The method of commissioning of the "Electronic cylindrical lock" is the same for all profile types.
The following points are a prerequisite for commissioning the "Electronic cylindrical lock":
A connection to the "Smart Access Point Pro". This must be the "Smart Access Point Pro"
■
that is used in the system.
"Smart Access Point Pro":
■
The "Smart Access Point Pro" must be ready for operation.
■
A PC is connected with the "Smart Access Point Pro".
■
The management software of the "Smart Access Point Pro" is opened on the PC.
■
The serial number of the "Electronic cylindrical lock". This is located on the reading head.
■
The batteries of the "Electronic cylindrical lock" (are supplied).
■
The maintenance card.
■
If locking rights for persons are to be assigned already during commissioning, also
■
transponder keys are required.
– It is recommended, however, to carry this out separately especially for larger projects.
– For the assigning of locking rights, see chapter 5.5 "User management" on page 131.
System Manual 2CKA001473B5074
When pulling the knob housing off, keep the reading head on the contact
protection provided.
Commissioning
│51