Prerequisites - ABB AccessControl System Manual

Table of Contents

3.2

Prerequisites

„Electronic cylindrical lock"

Every reading head must have a radio connection to the "Smart Access Point Pro" during

■

commissioning.

–

This radio connection can be established directly or indirectly via other devices.

–

The connecting path to their later area of application must be specified in the

management software of the "Smart Access Point Pro" prior to the installation of the

devices.

All "Electronic cylindrical lock" can be commissioned together locally. For this all devices of

■

the system must be located in close proximity to the "Smart Access Point Pro". After the

joint commissioning, the devices are then mounted at their area of application.

If additional devices are required for the application of the "Electronic cylindrical lock"

■

("RF/IP Gateway" or "RF Repeater"), they should have already been put into operation for

the commissioning of the "Electronic cylindrical lock".

"Smart Access Point Pro"

A "Smart Access Point Pro" is required for the application of the "ABB-AccessControl" system.

System Manual 2CKA001473B5074

Commissioning

│32

Table of Contents