Table of Contents
Advertisement
5.3.2
Add "Electronic cylindrical lock"
To add a "Electronic cylindrical lock", perform the following steps:
Fig. 90:
Add "Electronic cylindrical lock"
1. Click on the "Cylinder" button [1].
Fig. 91:
Enter "Electronic cylindrical lock" data
2. Enter the name of the "Electronic cylindrical lock" in field [1].
3. Assign the "Electronic cylindrical lock" to the building structure [2] (building, floor, room).
–
The assignment to the building structure can also be made later, see chapter 5.2
"Building structure" on page 95.
4. Enter the serial number [3] of the "Electronic cylindrical lock".
–
The serial number is located on the type plate in the battery compartment, see chapter
3.2.1 ""Electronic cylindrical lock"" on page 51.
5. Click on the "Save" button.
System Manual 2CKA001473B5074
Management software in the "Smart Access Point Pro"
│105
Advertisement
Table of Contents
