Advertisement
DP-4X ADJUSTMENT MARKER MOVEMENT USING CH DW KEY
ADJUSTMENT MARKER MOVES CLOCKWISE SPIRALING OUT BY CH DW KEY:
(Continued from Previous Page)
As can be seen in the Figure below, (See Figure 3) this identifies the first 25 stopping positions where the ad-
justment Point will stop with each press of the CH DW key on the Remote Control. This will continue until all
117 stopping positions have been accessed.
ADJUSTMENT MARKER MOVES COUNTER CLOCKWISE SPIRALING OUT BY CH UP KEY:
With each press of the CH UP (Channel Up) key on the Remote Control, the adjustment point moves in a
Counter Clockwise Spiral fashion to the outside of the screen. Or from the Outside of the screen back to the
Center.
NOTE 1:
There are the following Stopping Point Modes:
117 (13X9) Mode (Default) or Entered by pressing Blue Select (INPUTS) Key 5 times.
35 (7X5) Move Entered by pressing Red Select (0) Key pressed 5 times.
9 (3X3) Mode (Only be entered with Cleared RAM) Entered by pressing Green Select (INFO) Key 5 times.
NOTE 2:
The Adjustment Point is still moved in the Conventional way by pressing the following keys;
Move Up = (2) Key, Move Down = (5) Key, Move Right = (6) Key, Move Left = (4) Key
NOTE 3:
Selecting Colors to adjust;
(INFO) selects Green Adjustment Mode, (0) selects Red Adjustment Mode and (INPUTS) selects Blue.
NOTE 4:
Adjusting the particular location is still accomplished by using the Remotes Cursor Keys, up, down, left and
right.
Press CH DW (Channel Down) Marker Moves
18
19
17
5
16
4
15
3
14
13
Adjustment Point Marker Moves
Clockwise Spiraling Outward.
Figure 3
20
21
22
6
7
23
8
24
2
1
25
9
12
11
10
PAGE 06-11
Advertisement
