Advertisement
DP-4X ADJUSTMENT MARKER ON AND OFF CONTROL
ADJUSTMENT MARKER ON AND OFF:
Remote must be in Digital Convergence Adjustment Mode. See page 08-18.
This function can improve view of adjustment point during Digital Convergence Adjustment Mode (DCAM).
When the Service Only switch on the Def/Convergence PWB is pressed, the Digital Convergence Adjustment
Grid appears.
New for this year is the appearance of the Adjustment Point Marker. This Marker is demonstrated in Figure 1
by to two small solid lines that appear at the adjustment point. (See Figure 1)
Adjustment Point is Intersection of Dotted Lines
Press the LAST CH key on the Remote control, and the display only Normal Crosshatch appears. In this condi-
tion the two solid lines at the adjustment point disappears and the grid appears as previous years. The Adjust-
ment Point now is the intersection of the dashed colored blinking lines. (See Figure 2)
By repeatedly pressing the LAST CH key on the remote control, the display will toggle between Display
Marker and Non-Display Marker grid.
Marker is NOT displayed.
Figure 1
Adjustment Point Identified by Marker
Adjustment Point Marker.
Figure 2
PAGE 06-09
Advertisement
