Advertisement
DP-4X HORIZONTAL CENTER ADJUSTMENT (FINE)
Adjustment Preparation:
• Video Controls at Factory Reset
Condition.
• Convergence Adjustment should be
complete.
Adjustment Procedure NORMAL MODE:
1) Receive an (ATSC 480p 16:9) signal.
2
2) Enter the I
C Service Menu* and
select Item H POSI and Adjust the
data so that the Video is center and
the right and left hand side of the
picture are equal.
2
3) Exit from the I
C Menu.
Adjustment Procedure (1080i 16:9) HD
MODE:
1) Receive a 1080i (HDTV) signal.
2) Press the SERVICE ONLY switch
to return to normal mode.
2
3) Enter the I
C Service Menu* and
scroll to Item H POSI.
4) Press SELECT key, then H POSI
H is displayed. (This means the
1080i mode is entered. If Select isn't
pressed, H POSI H will not appear).
Adjust the data so that the Video is
center and the right and left hand
side of the picture are equal.
2
5) Exit from the I
C Menu.
NOTE: To enter the I
menu, with Power Off, press the INPUT
button and hold it down, then press the
POWER button and release. I
ment menu will appear.
2
C Bus alignment
2
C adjust-
PAGE 08-36
Advertisement
