Advertisement
THINGS TO KNOW IN THE DP-4X CHASSIS FOR DIGITAL CONVERGENCE
The Digital Convergence Process is very
similar to the Previous chassis.
However, there are some difference that
need attention.
•
New Remote Controls. (CLU-3842WL or
CLU-4341UG2) The Remotes must be
placed into *DCAM (See Note 2). before
using them for Digital
Convergence adjustments.
•
New Control for the Adjustment Point
Marker. It can be turned on or off.
•
Last Channel (LAST CH) toggles from
Cross marker to old style of Cursor
blinking crosshair.
•
New Addition to the Adjustment process
that automatically moves the Adjustment
point Clockwise or Counter Clockwise
from the center outward in a spiral
fashion or for the outside back towards
the middle.
•
Channel Up moves Clockwise and
Channel Down moves Counter
Clockwise.
•
Using an Outside Signal in conjunction
with the Grid or by itself for fine tuning
adjustments.
•
Pressing the MENU key on the remote
during DCAM will toggle in the following
order, Normal DCU Grid, Turns of Color
or Colors not being adjusted (except
Green), Picture and DCU Grid, Picture
with cursor, Picture with square marker
at adjustment point, back to DCU Grid
normal.
•
New Sensor Error Messages.
TO ENTER DIGITAL CONVERGENCE
ADJUSTMENT MODE WITHOUT
REMOVING THE SPEAKER GRILL:
1) Press the Magic Focus button on the
front control panel.
2) While Magic Focus is running, press the
Magic Focus button again. STOP ap-
pears.
3) While STOP is still on the screen, press
the INFO button on the remote control.
4) This enters the DCAM. (Remember, re-
mote control must be placed in the
DCAM mode before adjusting the Con-
vergence. (CLU-3842WL or CLU-
4341UG2)
5) After adjustments SAVE the data.
6) INITIALIZE the Sensors.
7) Press EXIT
8) Press the POWER button on the front
control panel.
Note: * DCAM means Digital Convergence
Adjustment Mode.
NOTE 2: To enter the Remote Control into
DCAM do the following;
FOR CLU-3842WL
1) Remote must be in the TV mode to
begin.
2) Press and hold down the ENT Key
3) Press the MENU and then INFO key.
4) Remote TV LED will blink 3 times to
indicate remote in the DCAM.
5) To Return the Remote Control to the
normal mode after convergence
adjustments are complete, press and
hold down the ENT key and enter 1345
to select Hitachi codes.
FOR CLU-4341UG2
1) Remote must be in the TV mode to
begin.
2) Press and hold down, "TV" Key.
3) Press all at one time, "MENU, INFO and
the (-) DASH Keys. Release all keys.
4) To Return the Remote Control to the
normal mode after convergence
adjustments are complete, press and
hold down the TV key and enter "0" then
"1" Keys.
Note: * DCAM means Digital Convergence
Adjustment Mode.
PAGE 08-18
Advertisement
