Advertisement
DP-4X SIDE PIN ADJUSTMENT
ADJUSTMENT
PREPARATION:
•
Receive an NTSC sig-
nal.
•
VIDEO control should
be set at Factory Preset
condition.
•
BEAM FORM adjust-
ment should be finished.
If the sides can not be made straight, make as straight as possible.
NOTE: If you are continuing with Service Adjustments, do not Power Off the set.
Leave the Set in this condition, (Cleared DCU RAM and the I
ADJUSTMENT PROCEDURE:
1) Press the SERVICE
ONLY button on the
DEF/CONV PWB and
the MUTE key on
Remote Control at the
same time.
Clears the DCU RAM
and brings up a single
crosshair.
2) Press and hold the
MENU button on the
front panel for 3
seconds.
The I
and Crosshair changes
to Crosshatch (Green).
Left and Right side of DCU crosshatch should be straight.
2
C menu appears
3) Choose EW PARA
(Side Pin) item by using
the Remote's thumb
stick down button.
4) Adjust SIDE PIN as
follows by using the
Remote's Thumbstick
left and right key.
5) Left and right side edge
of vertical DCU cross-
hatch line should be
straight.
•
Make the lines as
straight as possible
even if there's a little pin
error.
2
C Menu displayed.
PAGE 08-12
Advertisement
