Advertisement
DP-4X CHASSIS DCU CROSSHATCH PHASE ADJUSTMENT
Adjustment Preparation:
•
Cut Off adjustment should
be finished.
•
Video Control: Brightness
90%, Contrast Max.
Adjustment Procedure:
NORMAL MODE
1) Receive any NTSC signal.
2) Screen Format is Normal
3) Press the SERVICE
ONLY switch on the
Deflection / Convergence
PWB to enter DCAM.
4) Press the CC key on the
CLU3842WL Remote, or
the Fast Forward* Key
on the CLU4341UG2 Re-
mote. Extra line appears.
5) Then press the EXIT key.
(This is the Phase
adjustment mode).
4 and 6 keys on Remote
2 and 5 keys on Remote
Cursor Left and Right on Remote
Cursor Up and Down on Remote
New Remote Controls. (CLU-3842WL or CLU-4341UG2) The Remotes must be placed into *DCAM
To enter the Remote Control into DCAM see page 08-18.
*DCAM = Digital Convergence Adjustment Mode.
6) Adjust data value using
the keys indicated in the
chart, until the data
matches the values
indicated in the chart.
Saving the Data:
7) Press the EXIT key.
Crosshatch appears.
8) Press the CC key on the
CLU3842WL Remote, or
the Fast Forward Key on
the CLU4341UG2 Re-
mote. Extra line disap-
pears.
9) Press ASPECT key
TWICE to store the
information.
10)When Green dots are
displayed, press the
MUTE key twice to
return to DCAM grid.
PHASE MODE
ADJUST USING
11)Press the Service Only
Switch to return to Nor-
mal Mode.
NOTE:
*DCAM stands for (Digital
Convergence Adjustment
Mode)
*Fast Forward Key
NORMAL
Chassis All
Address
Data Value
PH-H
PH-V
CR-H
CR-V
F4
07
35
14
PAGE 08-06
Advertisement
