Interval Maintenance - MacDon R80 Operator's Manual

7.12.2 Interval Maintenance

INTERVAL
FIRST USE
100 HOURS OR
ANNUALLY *
END OF
SEASON
10 HOURS OR
DAILY
25 HOURS
50 HOURS
250 HOURS
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.
Form # 169089
MAINTENANCE/SERVICE
Refer To
1. Check Bevel Gearbox Lubricant Level.
2. Check Conditioner Drive Belt Tension. Except Grass Seed Header. See Section
7.9.3.1.
3. Check Hourglass Deflector Belt Tension – 16 Ft Only. See Section 7.9.8.1.
1. Check Hydraulic Hoses And Lines For Leaks.
2. Check Cutter Blades For Security And Condition.
3. Check Hourglass Deflectors For Security And Condition.
1. Grease Cutterbar Driveline Bearings.
2. Grease Roll Universal Shafts. Except Grass Seed Header.
1. Grease Roll Universal Shafts. Except Grass Seed Header.
2. Grease Roll Shaft Bearings. Except Grass Seed Header.
3. Grease Drive Belt Tensioner. Except Grass Seed Header.
4. Grease Gauge Roller Bearings.
5. Grease Converging Drum Bearings (Grass Seed Header).
1. Change Bevel Gearbox Lubricant.
2. Change Cutterbar Lubricant. Use only specified amount. Do not overfill.
SERVICE
BREAK-IN INSPECTIONS (previous page).
Refer To Section 6.14, STORAGE.
92
Model Year - 2010