Interval Maintenance - MacDon R80 Operator's Manual

7.13.2 Interval Maintenance

INTERVAL
FIRST USE
1. Check Bevel Gearbox Lubricant Level.
100 HOURS OR
2. Check Wheel Bolt Torques.
ANNUALLY *
3. Check Conditioner Drive Belt Tension.
END OF
SEASON
1. Check Hydraulic Oil Level.
10 HOURS OR
2. Check Hydraulic Hoses and Lines For
DAILY
1. Grease Cutterbar Driveline Bearings.
25 HOURS
2. Grease Roll Universal Shafts.
1. Grease APT Pivot.
2. Grease Steering Cylinder Pivot
50 HOURS
3. Grease Drive Belt Tensioner.
4. Grease APT Swivel.
1. Change Hydraulic Oil Filter.
250 HOURS
2. Change Cutterbar Lubricant.
500 HOURS OR
1. Change Hydraulic Oil.
3 YEARS
1000 HOURS OR
1. Change Pump Gearbox Oil.
3 YEARS
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.
Form # 169053
MAINTENANCE/SERVICE
Refer To
Leaks.
SERVICE
BREAK-IN INSPECTIONS (previous page).
4. Check Hourglass Deflector Belt Tension –
16 Ft.
5. Grease Wheel Hub Bearings.
Refer To Section 6.16 STORAGE.
3. Check Hourglass Deflectors For Security
and Condition.
4. Check Tire Pressure.
3. Grease PTO Shaft and Universals.
5. Grease Roll Shaft Bearings.
6. Grease Lift Cylinder Pivot.
7. Grease Lower Link Pivots.
3. Change Bevel Gearbox Lubricant.
112
Model Year - 2010