Table of Contents
Advertisement
ELECTRICAL
Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
Keep lights clean and replace burnt bulbs and
sealed beams.
To replace amber or red light bulbs:
1. Using a screwdriver, pry plastic lens (B) from
fixture.
2. Replace bulb and plastic lens.
NOTE: Bulb trade #1156.
To replace field lamp sealed beam:
1. Use a screwdriver to pry sealed beam from
rubber bezel (C). Work your way around
circumference, taking care not to break sealed
beam.
2. Disconnect wire (D) and connect new sealed
beam.
NOTE: Sealed beam trade #4411
3. Carefully push new sealed beam into rubber
bezel. Make sure it is properly positioned.
Form # 147021
MAINTENANCE/SERVICE
REPLACING AMBER OR RED LIGHT BULBS
45
B
C
REPLACING SEALED BEAMS
D
Issue 05/05
Advertisement
Table of Contents
