Table of Contents
Advertisement
PREPARING THE WINDROWER (continued)
5. Check the tires and inflate if necessary.
Recommended pressure is 24 to 28 psi (165 to
190 kPa).
CAUTION: When inflating tires, use a
clip-on chuck and extension hose
long enough to allow you to stand to
one side and not facing the tire.
6. Check the tension of all belts and adjust if
required. See Maintenance/Service section.
7. IMPORTANT: Check that main drive belt is
properly aligned. Misalignment will result in belt
failure. See "Main Drive Belt Alignment" in
Maintenance/Service section.
8. Lubricate the machine completely. See
Maintenance/Service section.
9. Check for proper assembly and adjustment and
make sure all bolts are tightened securely.
10. For 36 ft. units only: Adjust stabilizer stop bolt
(G) as follows:
- Position machine as when moving straight
ahead in field position. Stabilizer chain (H) will
be taut.
- Adjust stop bolt (G) to just contact stabilizer
channel (J).
Form # 147021
OPERATION
STAND TO ONE SIDE WHEN INFLATING TIRES
ADJUST STABILIZER STOP BOLT - 36'
8
Issue 05/05
Advertisement
Table of Contents
