Table of Contents
Advertisement
Windrower Model:
Perform these checks and adjustments prior to delivery to your customer. See the Operator's Manual and
Assembly Instructions for adjustment details.
CAUTION: Carefully follow the instructions given. Be alert for safety related messages
which bring your attention to hazards and unsafe practices.
Check for shipping damage or missing parts.
Bleed right reel lift cylinder.
Center reel between end sheets.
Adjust reel fore-aft position.
Check reel drive idler arm is properly located for reel fore-aft position.
Adjust reel clearance from cutterbar. (2 in. [50 mm])
Check main drive belt idler alignment.
Check main drive idlers mounting bolt torque. (80 - 90 ft. lbs. [110 - 120 N⋅m])
Grease float adjusting screw.
Check header flotation (100 - 150 lbs. [450 - 650 N])
Grease all bearings.
Grease both wheel casters until grease is forced out top or bottom of caster bearing.
Check tire pressure – 24 to 28 psi (165 – 190 kPa).
Turn drives by hand to check for binding. AVOID PINCH POINTS.
Check draper tracking and tension.
Adjust cutterbar level.
Run machine for 15 minutes, STOP MACHINE and check drives for belt/idler alignment and heated
bearings. Check knife sections for discolouration caused by misalignment of components.
Check hydraulic hose routing, ensuring adequate clearance with header and reel up or down.
Convert machine to transport position:
Check telescoping hitch operation.
Check transport pins install easily.
Check wheels caster properly into position.
Check transport width.
Bleed right wheel lift cylinder.
Check routing of electrical wiring and hoses in transport.
Check lights are functional.
Date Checked:
Form # 147021
PULL TYPE WINDROWER
PRE-DELIVERY CHECKLIST
Serial No:
Checked By:
Issue 05/05
Advertisement
Table of Contents
