To add a management point, select one from
management point, select one from
You can register up to 6 management points to monitor.
When finished, touch the OK button to return to the Emergency Stop Program Settings screen.
(11)
is the list of management points target of the Emergency Stop. Touch the Modify button
6.
and register management points, as in step 5.
NOTE
In the case of the system with Hydrobox, this function controls the air conditioners only, but
unable to control the water heater operation.
7. Using the Release Mode combo box (13), select the method of releasing the emergency stop
program from Automatic and Manual.
Using the Specification method combo box (14), select whether the Output list
of emergency stop targets or the list of those excluded.
NOTE
The management points, which was newly registered after creating the emergency stop
program, can be used as follows.
• On the program which uses the list
stopped emergently.
• On the program which uses the list
emergently.
When finished, touch the OK button to return to the Emergency Stop Control screen.
(10)
and touch the Add button. To remove a
(9)
and touch the Remove button.
(13)
(11)
as the list of emergency stop targets, it cannot be
(11)
as the list of those excluded, it can be stopped
User's Manual EM11A015B
intelligent Touch Manager
(12)
(11)
(14)
(11)
(12)
is the list
194