Table of Contents
Advertisement
Roof
90
not place any objects on the cover
R
behind the roll bars
not allow the load to push up the boot
R
separator
The boot separator can be used to cover lug-
gage and loads in the boot.
Opening and closing
To close: pull back boot separator : by
X
the handle in the direction of the arrow until
it engages on both sides in the eyelets on
the luggage compartment lip.
To open: grip the handle of boot separa-
X
tor :.
Press the release button in the handle of
X
boot separator :.
Boot separator : is unlocked.
Pull boot separator : up out of the eyelets
X
on the luggage compartment lip.
Push boot separator : forwards by the
X
handle, against the direction of the arrow.
Draught stop
Important safety notes
G
WARNING
If you use the draught stop in darkness or in
other conditions offering poor visibility, your
view to the rear is further impaired. There is a
risk of an accident.
Only use the draught stop when visibility con-
ditions are good.
G
WARNING
If the draught stop is not fitted correctly, it
could come loose during the journey and
endanger other road users. There is a risk of
an accident and injury.
Fit the draught stop as described.
! Fit or remove the draught stop only when
the roof is open. You could otherwise dam-
age the draught stop or the vehicle interior.
The draught stop offers protection from the
wind when driving with the roof down.
The draught stop can be fitted or removed
from the driver's side or passenger side.
Perform operations involving the draught
stop preferably on the side facing away from
traffic, after you have stopped the vehicle,
paying attention to road and traffic condi-
tions.
Fitting and removing the draught stop
Preparing for fitting
Example: preparing for fitting from the left side of
the vehicle
Draught stop
:
Locked latch
;
Unlocked latch
=
Fulfil the following conditions for fitting:
X
Advertisement
Table of Contents
