Table of Contents
Advertisement
Emergency spare wheel
336
Mount the collapsible emergency spare
X
wheel as described (
The collapsible emergency spare wheel
must be mounted before it is inflated.
Pull plug ? out of the housing.
X
Take the air hose out of the housing.
X
Insert the yellow hose connector of the air
X
hose into the guide in the housing and push
it into the fixture until the hose connector
engages.
Remove the cap from the valve on the col-
X
lapsible emergency spare wheel.
Screw union nut : on the air hose onto the
X
valve.
Make sure on/off switch A of the tyre
X
inflation compressor is set to OFF.
Insert plug ? into the socket of the ciga-
X
rette lighter or into a 12 V of power socket
in your vehicle.
Observe the notes on the cigarette lighter
(
page 268). Observe the notes on sock-
Y
ets (
page 269).
Y
Turn the key to position 1 in the ignition
X
lock (
page 141).
Y
Press on/off switch A on the tyre inflation
X
compressor to ON.
The tyre inflation compressor is switched
on. The tyre is inflated. The tyre pressure is
shown on pressure gauge =.
Pump the tyre to the specified tyre pres-
X
sure.
The specified tyre pressure is printed on
the yellow label of the emergency spare
wheel.
When the specified tyre pressure has been
X
reached, press on/off switch A to OFF, on
the tyre inflation compressor.
The tyre inflation compressor is switched
off.
Turn the key to position 0 in the ignition
X
lock.
If the tyre pressure is higher than the speci-
X
fied pressure, press pressure release but-
page 324).
Y
ton ; until the correct tyre pressure has
been reached.
Unscrew union nut : on the air hose from
X
the valve.
Screw the valve cap onto the collapsible
X
emergency spare wheel valve again.
Removing an air hose
To remove the hose from the tyre inflation
X
compressor, push down the rocker switch
on the hose connector and pull out the
hose.
Stow plug ? and the air hose in the lower
X
section of the compressor housing.
Stow the tyre inflation compressor in the
X
vehicle.
Advertisement
Table of Contents
