Table of Contents
Advertisement
Securing the vehicle against rolling
away
If your vehicle is equipped with a wheel chock,
it can be found in the tyre-change tool kit
(
page 295).
Y
The folding wheel chock is an additional
securing measure to prevent the vehicle from
rolling away, for example when changing a
wheel.
Fold both plates upwards :.
X
Fold out lower plate ;.
X
Guide the lugs on the lower plate fully into
X
the openings in base plate =.
Securing the vehicle on level ground
On level ground: place chocks or other
X
suitable items under the front and rear of
the wheel that is diagonally opposite the
wheel you wish to change.
Changing a wheel
Securing the vehicle on slight downhill gradients
On light downhill gradients: place
X
chocks or other suitable items in front of
the wheels of the front and rear axle.
Raising the vehicle
G
WARNING
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip over with the vehicle raised.
There is a risk of injury.
Only position the jack at the appropriate jack-
ing point of the vehicle. The base of the jack
must be positioned vertically, directly under
the jacking point of the vehicle.
The following must be observed when raising
the vehicle:
to raise the vehicle, only use the vehicle-
R
specific jack that has been tested and
approved by Mercedes-Benz. If the jack is
used incorrectly, it could tip over while the
vehicle is raised.
the jack is designed only to raise and hold
R
the vehicle for a short time while a wheel
is being changed. It is not suitable for per-
forming maintenance work under the vehi-
cle.
avoid changing the wheel on uphill and
R
downhill slopes.
before raising the vehicle, secure it from
R
rolling away by applying the parking brake
and positioning wheel chocks. Never
325
Z
Advertisement
Table of Contents
