Table of Contents
Advertisement
Flat tyre
298
If you come into contact with the tyre sealant,
observe the following:
Rinse off the tyre sealant from your skin
R
immediately with water.
If the tyre sealant comes into contact with
R
your eyes, immediately rinse them thor-
oughly with clean water.
If tyre sealant is swallowed, immediately
R
rinse your mouth out thoroughly and drink
plenty of water. Do not induce vomiting,
and seek medical attention immediately.
Immediately change out of clothing which
R
has come into contact with tyre sealant.
If an allergic reaction occurs, seek medical
R
attention immediately.
! Do not operate the tyre inflation com-
pressor for longer than eight minutes at a
time without a break. It may otherwise
overheat.
The tyre inflation compressor can be oper-
ated again once it has cooled down.
Comply with the manufacturer's safety
instructions on the sticker on the tyre infla-
tion compressor.
Using the TIREFIT kit
TIREFIT sticker, 2-part
Do not remove any foreign objects which
X
have penetrated the tyre, e.g. screws or
nails.
Remove the tyre sealant bottle, the accom-
X
panying TIREFIT sticker and the tyre infla-
tion compressor from the stowage space
under the boot floor (
Affix part : of the TIREFIT sticker within
X
the driver's field of vision.
Affix part ; of the TIREFIT sticker near the
X
valve on the wheel with the defective tyre.
Remove filler hose B and plug = from the
X
bottom section of the tyre inflation com-
pressor housing.
Slide the yellow filler hose connector into
X
the mounting on yellow cap A of tyre seal-
ant bottle : until the plug engages.
With the sealing rings in front, slide yellow
X
cap A of tyre sealant bottle : into the
mounting of tyre inflation compressor ;.
The cap must engage in both hooks.
Remove the cap from valve C on the faulty
X
tyre.
Screw filler hose D onto the valve.
X
page 295).
Y
Advertisement
Table of Contents
