Table of Contents
Advertisement
Setup, Configuration and Calibration
6.2.8 Display Resolution - Setting Resolution
The instrument is equipped with the ability to display several levels of resolution. The instrument
can display up to four digits to the right of the decimal place for turbidity readings below 10 NTU.
The default setting is 000.00 If the last digit or two is not stable, adjust the resolution to hide
these insignificant digits.
To change the Resolution:
1. Enter the CONFIG mode by pressing the
then press the
2. Press the
button to move to the next menu until RES is displayed, then press the
3. Change the resolution by pressing the
4. When the desired digit resolution has been selected, press the
next menu or the
6.2.9 LCD Brightness - Setting the LCD backlight brightness
The LCD backlight brightness may need to be adjusted. This is of particular interest if multiple
instruments are located in the same area and it is desired for the entire group to have the same
appearance. Ten levels are available. The default brightness is 8.
To adjust Backlight Brightness:
1. Enter the CONFIG mode by pressing the
illuminated, then press the
2. Press the
button to move to the next menu until BRT is displayed.
3. Change the brightness by pressing the
4. When the desired brightness has been selected, press the
menu or the
button to exit and return to AUTO.
100193 Rev 0 ba77254e01 11/2020
button.
button to exit and return to AUTO.
button.
or
buttons until the arrow beside CONFIG is illuminated,
or
button.
and
buttons until the arrow beside CONFIG is
or
button.
button to accept it and move to the next
Turb PLUS 2000
button.
button to accept it and move to the
33
Advertisement
Table of Contents
