Table of Contents
Advertisement
After using the product, wipe off any moisture.
- Moisture from the shower hose that dripped onto the floor.
- Moisture adhered to the main unit cover and outside the basin.
After use, be sure to wipe off any
Caution
When the floor is wet, be sure to wipe
The drain cap must be detached from the
drain outlet when the product is not in
use. If the lid is not detached, the lid may
Caution
accidentally close, and the water may
overflow the basin from the failure to
notice water discharge, thus resulting in
water leaks.
Adjusting the Basin Movement
Rotate the basin adjustment screw provided on the
main unit with the supplied hexagonal-head wrench
and set to an adequate position. The screw is provided
on the right and the left sides.
<When basin movement is heavy>
Rotate the screw in the counterclockwise direction.
<When basin movement is light>
Rotate the screw in the clockwise direction.
The adjustment should be done on the opposite side.
The basin adjustment screw will fall off if loosened too much. Pay attention to avoid losing the
The basin adjustment screw is provided on both the right and the left sides. Rotate the screw
Caution
Do not drop the hexagonal-head wrench on the main unit. Failure to take this precaution may
Be sure to check basin movement after finishing the adjustment.
moisture from all parts other than the
basin. Leaving the product with water
drops may result in failure or any
contamination will not be removed.
the moisture off. Wet floors increase
the possibility of slipping and falling or
water leaks to the downstairs, thus
resulting in accidents.
screw too much.
the same amount on both sides to adjust movement. Adjusting only one side may result in
breakage of the basin.
result in breakage of the main unit.
Heavy
<Adjustment on the Left Side of Basin>
Drain cap
Basin Adjustment Screw
Hexagonal-head
Wrench
Light
Advertisement
Table of Contents
