Status Indicator (Gige Cameras) - Photon Focus MV8-D8424-G01-GT User Manual

Cmos camera series with gige interface
Hide thumbs Also See for MV8-D8424-G01-GT:
Table of Contents

Advertisement

13.5 Status Indicator (GigE cameras)

Four LEDs (S1, S2, S3 and S4) on the back of the camera give information about the current
status of the GigE CMOS cameras.
Function
IO Fault
RS485 Activity
LED0 (User Led)
LED1 (User Led)
Link Activity
GigE Link established
10 GigE Link established
1, 2.5 or 5 GigE Link
established
SFP TX Fault
SFP Fibre Loss
Table 13.7: LED S1, S2, S3 and S4 configuration of the CMOS cameras
IO Fault Voltage fault indication (see Section 13.6.2)
RS485 Activity On: RS485 communication active; Off: RS485 communication inactive
LED0 (User Led) User configurable with LineSelector LED0 in the section DigitalIOControl.
Default Configuration: It pulsates, when the camera is not grabbing images. It means, the
intensity starts from dark and goes slowly to bright and slowly to dark again. When the
camera is grabbing images the LED blinks at a rate equal to the frame rate. At slow frame
rates, the LED blinks. At high frame rates the LED changes to an apparently continuous
green light, with intensity proportional to the ratio of readout time over frame time.
LED1 (User Led) User Configurable with LineSelector LED1 in the section DigitalIOControl.
Default Configuration: Indicates an active serial communication with the camera.
Link Activity On: GigE communication active; Off: GigE communication inactive
GigE Link established On: GigE Link established; Off: No Link established
10 GigE Link established On: 10GigE link established; Off: No Link established
1, 2.5 or 5 GigE Link established On: 1, 2.5 or 5GigE link established with a 10GigE camera;
Off: No Link established
SFP TX Fault On: SFP TX Fault detected; Off: No SFP TX fault
SFP Fibre Loss On: Fibre Loss detected; Off: No Fibre loss
.
MAN094 03/2021 V1.0
GigE (G2)
10 GigE Copper (GT)
S1 red
S1 green
S2 green
S2 orange
S4 orange (blink)
S3 green (solid)
13.5 Status Indicator (GigE cameras)
S3 red
S3 green
S4 green
S4 orange
S2 red (blink)
S1 green (solid)
S1 red (solid)
10 GigE Fibre (FB)
S1 red
S2 red
97 of 139

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Mv8-d8424c-g01-gt

Table of Contents