Encoder Reset Source - Photon Focus MV8-D8424-G01-GT User Manual

Encoder Idle Encoder is idle, either no trigger sources are configured or the encoder is waiting
on the reset.
Encoder Up The position counter last incremented.
Encoder Down The position counter last decremented.
Encoder Static The position counter hasn't changed in the EncoderTimeout period. The
encoder also switches to this state when it is reset while in the idle state.
The EncoderTimeout is configurable by the user. If set to zero, no timeout is applied and the
encoder simply stays in the Up respectively Down state until the direction reverses. The
EncoderTimeout property only affects the encoder status.

6.4 Encoder Reset Source

The encoder reset source selects the signal which will be the used to reset the encoder. The
following signals sources are available:
Off Disables the encoder reset.
Acquisition Trigger Resets with the reception of the acquisition trigger.
Acquisition Start Resets with the reception of the acquisition start event.
Acquisition End Resets with the reception of the acquisition end event.
FrameTrigger Resets with the reception of the frame trigger.
Frame Start Resets with the reception of the frame start event.
Frame End Resets with the reception of the frame end event.
Frame Burst Start Resets with the reception of the frame burst start event.
Frame Burst End Resets with the reception of the frame burst end event.
Exposure Start Resets with the reception of the exposure start event.
Exposure End Resets with the reception of the exposure end event.
User Output 0 ... 7 Resets the encoder as long as the selected user output bit is asserted. The
encoder remains in reset state until the selected user output bit is deasserted again (see
Section 4.7).
Counter 0 ... 3 Start Resets with the reception the chosen counter start event.
Counter 0 ... 3 End Resets with the reception the chosen counter end event.
Timer 0 ... 3 Start Resets with the reception the chosen timer start event.
Timer 0 ... 3 End Resets with the reception the chosen timer end event.
Software Signal Pulse 0 ... 7 Resets with the reception of chosen software signal pulse event
(see Section 4.7).
Line Input Resets when the specified encoder trigger activation condition is met on the chosen
line.
Line input source has additionally a activation configuration, which needs to be set
accordingly. Following configuration values are available:
MAN094 03/2021 V1.0
6.4 Encoder Reset Source
53 of 139