Mounting Stators With Cooling Jacket And Mounting Ring (Optional) - Bosch rexroth MBT Manual

316/409
Installation
12.6 Mounting stators with cooling jacket and mounting ring (Op‐
tional)
Bosch Rexroth AG R911298798_Edition 08
● To facilitate assembly, Bosch Rexroth provides a mounting
ring for frame sizes 450 and 530. For more information on
the mounting ring, please refer to
on page
● All screwed connections are equipped with a liquid screw
lock. Refer to
The following figures show the general mounting sequence. Comply with the
machine manufacturer's special mounting instructions. For details about ex‐
isting threaded holes, tightening torques and screw-in depths, please refer to
the particular rotor or stator dimension sheet.
Mount the motor according to the following schematic procedure:
1. Lower the prepared machine housing down to its final position while it is
centered over the stator-rotor package. While doing so, ensure that the
stator centering device appropriately guides the housing and that the
housing does not get jammed.
① Rotor
② Stator
③ Mounting ring
Fig. 12-6: Mounting the stator-rotor package
2. Fasten the stator flange to the stator and also to the machine housing
using the mounting screws ④ and ⑤.
MBT High Synchronous Torque Motors
229.
Chap.12.3 .
chapter 7 "Accessories"
1
2
3