Transport And Storage; Transporting The Axial Piston Unit; Transporting By Hand; Transporting With Lifting Device - Bosch 70 Series Instruction Manual

Axial piston fixed motor
Table of Contents

Advertisement

Dimensions and weights
Transport with eye bolt

6 Transport and storage

Always observe the required ambient conditions for transport and storage, see
Chapter 6.2 "Storing the axial piston unit" on page 23.
Notes on unpacking can be found in Chapter 7.1 "Unpacking" on page 25.

6.1 Transporting the axial piston unit

The following transportation options are available depending on the weight and
duration of transport:
• Transport by hand (chapter not relevant for this axial piston unit)
• Transporting with lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size
80
Weight
kg
23
Width
mm
Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height
mm
Depth
mm
Weight may vary by equipment.

6.1.1 Transporting by hand

Axial piston units with a weight of up to 15 kg can be transported manually for a
short time if necessary.
CAUTIOn! Danger from heavy loads!
Risk to health from carrying axial piston units.
Use suitable lifting, lowering and moving methods.
Wear your personal protective equipment (e.g., safety goggles, safety gloves,
suitable working clothes, safety shoes).
Do not use sensitive attachments to transport the axial piston unit (e.g., sensors
or valves).
Carefully place the axial piston unit on the seating to prevent it from being damaged.

6.1.2 Transporting with lifting device

For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt or a lifting strap.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
For all female threads, use a stud end from the same system of units and of the
correct size.
To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is stated in the installation drawing.
Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20 %.
Transport and storage
90
107
23
23
RE 91071-01-B/03.2015, A2FM/A2FE Series 70, Bosch Rexroth AG
21/52

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rexroth a2fmA2fe

Table of Contents