Unintendend Use; Qualification Of Personnel; General Safety Instructions; Product- And Technology-Dependent Safety Instructions - Bosch rexroth MKE Operating Manual

8 / 60

Product- and technology-dependent safety instructions

power cables, using shielded cables, ...). The
EMC instructions of the converter manufacturer
must be observed.
Die Inbetriebnahme ist solange untersagt, bis die
Konformität mit diesen Anforderungen festges-
tellt ist.
2.1.2

Unintendend use

Any use of the MKE motors outside of the speci-
fied fields of application or under operating con-
ditions and technical data other than those speci-
fied in this documentation is considered to be
inappropriate use.
Do not use the motors if the ambient conditions
require a higher ATEX protection category than
specified on the type plate of the motors.
Direct operation on the three-phase network is
forbidden.
2.2

Qualification of personnel

Any work with or on the described product may
only done by qualified or skilled personnel. For
the purpose of this manual, qualified personnel
means persons who are familiar with trans-
porting, installing, mounting, commissioning and
operating the components of the electrical drive
and control system and the associated hazards
and have an appropriate qualification for their
job. Qualification of personnel contains knowl-
edge and observance of the country-specific
standards for users.
All persons working on, with or in the vicinity
of an electrical system must be informed of the
relevant safety requirements, safety guidelines
and internal instructionsEN 50110-1:2013.
2.3 General safety instruc-
tions
Important! Please read all instructions before
motor installation.
Bosch Rexroth AG
MKE Synchronous Servomotors
Do not install or operate motors or components
of the electric drive and control system before
you have not carefully read all delivered docu-
ments.
Please observe the particular applicable national,
local and system-specific regulations, the safety
instructions in the documentation and the
warning and informative labels on the motors.
Improper use of the motors and failure to follow
the safety instructions in this document may
result in material damage, personal injury, elec-
tric shock or, in extreme cases, to death!
In the case of damage due to non-observance
of the safety notes, Bosch Rexroth assumes no
liability.
Applications for functional safety are only allowed
if the motors have the SI‑sign on the rating plate.
2.4 Product- and technology-
dependent safety instruc-
tions
2.4.1 Protection against explosion
hazard
Product use only in hazardous areas according to
the specified labeling on the product
This product is only allowed to be used in an
area of use which is specified on the type plate
according to the explosion protection standards.
In the case of several Ex designations labelled
on the type plate, like gas and dust protection,
please observe that during operation only one
hazardous atmosphere occurs - no combination
of several.
Do any maintenance in non-hazard atmosphere.
Observe the conditions on use
Observe the notes in the application conditions
and do not exceed the specified limit values.
Observe residual risks
R911414374, Edition 01