Table of Contents
Advertisement
F5: SKP
This function enables you to easily skip backward or forward – switching the
console focus from the currently active KVM port to the previous or next
available one.
The selection of computers that are available for Skip Mode switching is made
with the Scan–Skip mode setting under the F3: SET function (see SCAN–SKIP
MODE, page 33). When you are in Skip Mode, press:
[←]
To skip to the previous accessible port on the list.
[→]
To skip to the next accessible port on the list.
[↑]
To skip to the last port of the previous station on the List.
[↓]
To skip to the first port of the next station on the List.
Note: When you skip, you only skip to the previous or next available
computer that is in the Scan–Skip Mode selection.
If a Port has been selected for Scan–Skip Mode, when the focus switches to
that port a Left/Right Triangle symbol appears before its Port ID Display
to indicate so.
While Skip Mode is in effect, the console will not function normally. You
must exit Skip Mode in order to regain control of the console.
To exit Skip Mode, press [Space] or [Esc].
Chapter 4. Local Console Operation
37
Advertisement
Table of Contents
