Navigation - Uwatec Galileo HUD User Manual

3.2.4

Navigation

If the Navigation function has been pre-
selected, then you can turn directly to
the navigation screen which provides
information on the direction you need to
travel while at depth.
If the Navigation function was not pre-
selected, you can activate it by pressing
the push-wheel, choosing the Navigation
menu, then selecting either the compass or
the GPS coordinates which you have set in
advance. (see chapter: Navigation)
The HUD's GPS functions only at the
surface. However, it can be used while in
Dive Mode if you need to briefly return to
the surface to orient yourself.
The HUD allows you to spend up to 3
minutes on the surface during a dive before
ending that dive. This means you can
surface, switch your HUD to GPS mode,
confirm your position, and then continue
your dive.
58
Applying this scenario to the above screen,
upon reaching the surface and switching to
GPS mode you would be provided with the
following information:
Top of screen:
• "--" (no depth);
Middle of screen:
• "Arrow" (indicates the direction you
have to move to come to your waypoint
course).
• "0" (your current course).
• i.e., you have to travel to the right
until "0" increases to "125," which is
the waypoint heading. At that point, 2
arrows will appear, indicating that you
are on course.
• "37.03" (the distance to the waypoint).
• "125" (the waypoint heading).
• "GPS" (indicates that the GPS signal
is activated / time since the latest GPS
signal).
Bottom of screen:
• "ZURISEE" (the name of the waypoint).
• "19:17" (the current dive time)
F
NOTE: the GPS works only at the
surface.
GALILEO HUD USER MANUAL