Table of Contents
Advertisement
F
NOTE: You can extend the timeout
period by giving the wheel a short
press.
9. Wait until the transmitter and HUD are
connected. Once a successful pairing
is made the screen will display "OK"
and revert to the Pairing screen.
At the same time, on the Gas menu screen
a green lightning symbol now shows that
the transmitter is paired to that gas.
To pair another transmitter start at Step 3
and repeat the process.
If at any time you decide to abort the pairing
procedure, press-and-hold the push-wheel
and the HUD will stop the pairing process
and the previous settings will remain.
Also, the pairing of the selected gas will be
canceled if the timeout countdown goes to
0.
26
F
NOTE: The transmitter must have
been unpressurized for at least 40
seconds prior to attempting a pairing
operation; if not, it will not transmit the
pairing sequence.
Also, a transmitter can only be paired
to one tank designation. If you pair the
same transmitter to a second tank
designation, the first pairing will be
erased. However, you can pair more
than one SCUBAPRO dive computer
to the same transmitter.
Finally, when performing the pairing
operation, make sure that only one
transmitter is activated within 2.5m/8ft
so that you will pair to the right tank.
After a successful pairing, on the Surface
screen the tank pressure will appear in
either BAR or PSI in the lower left hand
corner, accompanied by a pressure bar
running up the left side of the screen.
If "---" appears in the lower left hand corner
instead of a pressure value, that means the
HUD is paired but no signal is available.
GALILEO HUD USER MANUAL
Advertisement
Table of Contents
