Advertisement
Quick Links
Advertisement
Related Manuals for Uwatec G260
Summary of Contents for Uwatec G260
- Page 1 MAINTENANCE PROCEDURE G260 revision 03 2013-04...
- Page 2 ! - ! 2 13 MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
- Page 3 ! - ! 3 13 MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
- Page 4 SCUBAPRO/ UWATEC appointed staff. This procedure is a generic description for the G260. The attached schematic is an overview for the maintenance procedure. The dedicated regulator schematic must be used for parts replacements.
- Page 5 ! - ! 5 13 Unscrew the cover assy, remove the ring and diaphragm. MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
- Page 6 Remove also the (anti friction) sleeve from the inlet tube. 20. To clean the inlet tube properly the flow switch must be removed. MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
-
Page 7: Parts Cleaning
23. It is not necessary to carry out this step unless the exhaust valve needs replacement. Pull on the exhaust valve to remove it from the case. • PARTS CLEANING Refer to the parts cleaning procedure. MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04... - Page 8 Place the o-ring on the adapter. If the (anti friction) sleeve has been removed, it must be replaced by a new one. Take care that it is placed correctly on the inlet tube. MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
- Page 9 10. Insert the flow switch on the inlet tube. The triangular tip should be facing the adjust- ment knob side. 11. The G260 offers the possibility of reversing the hose side. The standard configuration is the hose that comes over the RIGHT shoulder. ...
- Page 10 22. Assemble the spring and purge button in the cover assembly. The G260 offers a anti set possibility to prevent the orifice to set in the seat. After assembly of the purge button check this by lightly push on the purge and simultaneously turn the purge of a turn anti clockwise.
- Page 11 If there is no leakage, the 2 stage can be adjusted. Connect the Digi-Mag adapter mouthpiece to the G260 mouthpiece and turn on the Digi-Mag. Zeroize the Digi-Mag pressure sensor if needed.
- Page 12 10. Check the final adjustment: it must be possible to push the purge button 2 mm without a leakage of the 2 stage. 11. Remove the adapter mouthpiece of the Digi-Mag from the G260 mouthpiece. 12. Fit the plug in the adjustment knob. 13. Close the tank valve, purge and remove the 2 stage adjustment tool. ...
- Page 13 13 13 MAINTENANCE PROCEDURE G260 – REVISION 03 - 2013-04...
Need help?
Do you have a question about the G260 and is the answer not in the manual?
Questions and answers