Mecmesin MultiTest-d Operating Manual page 23

Appendix 3
Packing instructions for MultiTest 0.5- d , 1 -d & MultiTest 2.5 -d motorised test
frames when returning to Mecmesin Limited
1. Set the crosshead to approximately the centre of the test frame. Remove the four rubber feet
from the base.
2. Place the plastic foam collar over the column ensuring that the collar does not hang over
the base casting.
3. Lay the test frame into the smaller box with the control panel facing upwards and with the
base facing the end with the four holes.
4. Position the wooden back plate on the box and retain the plate through the box to the base
casting using four M6x35 sockets-head screws fitted with large M6 plain washers.
5. Place all accessories listed to be despatched with the stand in the box with the test frame,
including the feet. Ensure that the accessories and operator manual/handbook are suitably
wrapped for protection in transit.
6. Place two of the four plastic foam spacers into the outside box so that they will support the
ends of the inner box (longest sides uppermost).
7. Carefully place inner box into outer box, ensuring that inner box rests evenly on foam
spacers
8. Close and then seal the inner box with a suitable adhesive tape.
9. Place the remaining two foam spacers over the ends of the inner box, so they will support
the ends as per the bottom two spacers.
10. Close and then seal the outer box with a suitable adhesive tape.
11. Attach despatch wallet with relevant paperwork for end destination.
If you have any feedback regarding Mecmesin, its products or services, which you would like
to share with us, please contact Mecmesin at: info@mecmesin.com
page 22