Permanent Codes; Temporary Codes; Time Restricted Codes; Delete All Codes - AES global Cellcom Prime 5AB Manual

9999#73*#
Service & diagnostic messages (no passcode required for some of these!)
*20#
*21#
*22#
*23#
1234#25#
9999#
81Xcode#time#
9999#
83#day,day,day
#time1,time2#
code#
9999#
82#hours#
code#
9999#84code#
9999#84*#
9999#80X#
9999#78XXX#
9999#79text#
1234#X#
day,day,day#
time#
1234*X#
9999#86XXX#
9999#86*#
9999#87??#
Do Not Disturb (push button de-activated during set times)
1234#21#ON#
9999#
21#day,day,day
#time1,time2#
P a g e | 25
Delete all caller ID numbers
Check reception level 1-31 (no passcode needed)
Check stored numbers. O = dial out number. I = dial in
number. E = end of message. (no passcode needed)
Check input status and relay status. (No passcode needed)
Sends SMS messages of the last 20 events.
Check stored keypad codes.
Keypad Programming
Permanent codes - X=1 or 2 for relay 1 or 2. Code = 4-6
digits. Time = 1-9999 seconds, or 0 for latching code.

Time restricted codes

Day = day of the week e.g. mon,tue,wed,thur,fri.
Time1 = start time. Time2 = end time (24 hr format, no colon.
E.g. 11:30pm = 2330. 8.30am = 0830.
Code = pin code 4-6 digits.

Temporary codes

Hours = time to expire in hours (1-168 hours).
Code = Pin code 4-6 digit code.
Delete code – Code=known code to be deleted.

Delete all codes.

X=1 to disable. X=2 to enable.
X=phone number to send notifications to. (*=delete number)
X=text to send to the receiving phone e.g. "gate opened"
Automatic Time Clock Trigger Times
X=1,2.3 (trigger, latch, unlatch relay 1) 4,5,6 (relay 2)
Day = days of the week (mon,tue,wed,thur,fri,sat,sun)
Time = time of day (24 hr format, no colon. E.g. 8:30am =
0830)
Delete ALL automatic trigger times.
Clock Sync - Auto Time Calibration after Power Fail
X=telephone number of SIM inside the intercom.
Delete the phone number.
Summer Daylight Auto Correct
?? = number of days between SMS calibration SMS should
be sent. 0 = no message sending.
ON = activated. OFF = de-activated.
Enter all active days during which button should operate.
Enter start and end time button should operate
(24 hr format, no colon. E.G 8:30am = 0830)
Notifications
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
OFF
N/A