CARDIOSTRONG FX80 Assembly And Operating Instructions Manual page 23

Step 10: Alignment of the feet
If the floor is uneven, you can stabilise the equipment by turning the two setting screws under the
main frame.
1. Lift the equipment on the desired side and rotate the setting screws under the main frame.
2. Rotate the screws clockwise in order to remove them and to raise the running surface.
3. Rotate them counterclockwise in order to lower the running surface.
Step 11: Connecting the equipment to the mains supply
࣑ ATTENTION
The equipment must not be connected to a multiple socket, otherwise it cannot be guaranteed
that the equipment will be supplied with sufficient power. Technical errors can result.
Plug the power plug into a wall outlet that complies with the instructions in the chapter on electrical
safety.
23