Safety During Operation - Siemens VersiCharge AC Wallbox IEC Operating Instructions Manual

2.5

Safety during operation

Observe the following points when operating the Wallbox, as well as the applicable regional
standards and regulations. Failure to follow safety instructions may result in hazardous
situations that could cause death or serious injury.
Electrical hazards
The Wallbox uses 230 V AC or 400 V AC supply voltage. Touching live parts may cause electric
shock and could be fatal.
Work on the electrical installation may only be carried out by trained electricians and at zero
current.
• Pull the plug, not the mains cord.
• Never touch the plug with wet hands.
• Do not perform any installation, maintenance, or configuration work during a
thunderstorm.
• Do not connect the vehicle to or disconnect it from the Wallbox during a storm.
Charging cable and socket
Defective connectors or cables may cause fire. Decommission the system if there are defects.
Have the defective parts repaired by qualified personnel.
Do not bend or squeeze the charging cable; do not run it over sharp edges, and use it only
within the permissible temperature range.
Inspect sockets and the charging cable for damage on a regular basis.
VersiCharge AC Wallbox IEC
Operating Instructions, 12/2021, A5E50366109-AA
Safety information
2.5 Safety during operation
13