Safety During Electrical Installation - Siemens VersiCharge AC Wallbox IEC Operating Instructions Manual

Table of Contents

Advertisement

Electrical cables
There is a risk of electric shock due to exposed electrical connections and components.
Before starting the installation work, check that the supply cable has been disconnected from
the mains and secured against restart.
If damage or tampering is visible, do not operate the Wallbox.
Crushing hazard
Ensure that persons maintain sufficient distance to avoid injury when putting the Wallbox
down.
2.3

Safety during electrical installation

Observe the following points for the electrical installation. The electrical connection of the
Wallbox may only be performed by skilled electricians and may only be carried out in a
deenergized state. Follow the installation and connection instructions. Observe the applicable
regional standards and regulations, such as the five safety rules (see also The five safety rules
for electrical work (Page 12)). Failure to follow safety instructions may result in hazardous
situations that could cause death or serious injury.
Risk of electric shock
The Wallbox operates with 230 V AC or 400 V AC supply voltage. Touching live parts may
cause electric shock and could be fatal. To prevent any hazard, only qualified and trained
electricians may open the Wallbox.
Before opening the Wallbox, switch off all power supplies for the device. Secure the Wallbox
against being switched on again.
Damage to sockets and charging cable
Inspect sockets and the charging cable for damage on a regular basis. Damaged charging
cables endanger safe operation.
If you detect damage to the charging cable, do not commission the cable or stop a running
charging process. Deenergize the charging cable without touching the cable. Ensure that the
device cannot be switched back on.
If you notice damage to the Wallbox, take it out of service. To do this, disconnect the Wallbox
from the power supply and secure it against being switched on.
Defective connectors or cables may cause fire. Decommission the system if there are defects.
Have the defective parts repaired by qualified personnel.
VersiCharge AC Wallbox IEC
Operating Instructions, 12/2021, A5E50366109-AA
Safety information
2.3 Safety during electrical installation
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Versicharge 8em1310 series

Table of Contents