Mounting / Installing / Connecting
4.7 Limiting the charging current
Setting the amperage of the Wallbox unit*
Figure 4-6
1. Open the cover.
2. Remove the protective cover.
3. Set the desired charging current by turning the selector switch to the corresponding value.
4. Close and secure the cover of the Wallbox. Check that the seal is sitting correctly.
Note
In positions 5 to 9, the current is increased to no higher than the maximum value for which
the hardware is designed.
32
Charging current
VersiCharge AC Wallbox IEC
Operating Instructions, 12/2021, A5E50366109-AA