Siemens VersiCharge AC Wallbox IEC Operating Instructions Manual page 54

Different models
The charging process is described for the socket version with type 2 charging port.
The procedure is largely identical for the following version.
• Fixed charging cables type 2
The following deviations may occur during the sequence:
• Plugging and unplugging directly at the Wallbox
• Connector lock
Start charging
Proceed as follows to start charging:
1. Check if the required charging point is ready for operation: The Power LED must be lit up.
2. Log in to the Wallbox.
– If the RFID function is activated on your device, hold your RFID card in front of the card
– Register on the device with a method supported by the operator, for example via an
3. After successful authorization, the Wallbox can be used.
4. Open the cover and insert the plug of the charging cable into the socket of the Wallbox.
Make sure that the charging cable is not damp or dirty.
5. Insert the socket of the charging cable into the connector system of the electric vehicle.
Follow also the instructions of the vehicle manufacturer.
6. The communication connection to the vehicle is established. This process can take some
time depending on the connection speed and reaction speed of the backend and vehicle.
7. The Wallbox locks the plug into the socket. The "Vehicle connected" LED lights up.
8. After successfully locking the connector, the charging process starts automatically. The
"Charging active" LED lights up. The vehicle is now being charged. The connectors are still
protected against unauthorized removal.
9. The Status LEDs inform you about the current charging status.
10. The LED bar display and the LED "Charging process active" extinguish when the charging
process is completed or stopped.
The LED bar display indicates that current is flowing to the vehicle and the vehicle battery is
charging. The LED bar display does not light up in the following cases:
• The vehicle is not drawing power.
– The Wallbox is pausing, for example, because of load management
– The vehicle pauses the charging
• The charging of the vehicle battery is completed.
VersiCharge AC Wallbox IEC
Operating Instructions, 12/2021, A5E50366109-AA
reader. An acoustic signal is emitted.
app.
Operation
6.2 Charging
53