Table of Contents
Advertisement
Assembly
Comply with the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 15).
• Comply with the applicable national and sector-specific regulations.
• When using the motor within the European Union, comply with the specifications laid down
in EN 50110‑1 regarding safe operation of electrical equipment.
5.1
Safety instructions for installation
Injury and material damage caused by inappropriate fastening material
If screws of an incorrect property class have been selected or if they have been fastened to an
incorrect tightening torque, they may break or become loose. This will cause the machine to
move, which could damage the bearings. The rotor could smash into the machine enclosure and
machine parts could be flung out of place. This can result in death, serious injury or material
damage.
• Comply with the required property classes for screwed connections.
• Tighten the screwed connections to the specified tightening torques.
Injury and material damage caused by incorrect machine alignment
If the machine has not been properly aligned, this will mean the fastening parts are subjected
to stress/distortion. Screws may become loose or break, the machine will move, machine parts
could be flung out of place. This can result in death, serious injury or material damage.
• Carefully align the machine to the driven machine.
Material damage caused by improper handling
Mounting parts such as temperature sensors or speed sensors are attached to the machine and
could be ripped off or destroyed as a result of improper handling. This could lead to machine
malfunctions, extending even to total loss of the machine.
• Use suitable steps when carrying out installation work on the machine.
• Do not stand on cables or attachments during installation. Do not use attachments as steps.
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 11/2023, A5E52779956A
5
61
Advertisement
Table of Contents
