Roland VersaCamm VS-640 Service Notes page 288

Fully Utilize the Media Heating System
!! IMPORTANT !!
To obtain stable temperature, use the machine at an ambient temperature of 20 to 32°C (68 to 90°F).
The optimal temperature for the media varies according to the type of media and differences in the print mode.
If the ink forms lumps or smudges, raise the temperature. If it still occurs even after raising the temperature, try
using a print mode of higher image quality by VersaWorks. If problems persist, try reducing the amount of ink by
VersaWorks.
Fully Utilizing the Correction Function *
Alleviating Horizontal Bands and the Like (feed correction function) *
Adjusting Head Height to Match Media Thickness *
!! IMPORTANT !!
* These adjustments are required for each Media individually.
If you are setting Feed Calibration on your machine, check in advance that [Use
Printer Settings] is set on VersaWorks.
Accommodating to the Types and Condition of Media
Using Transparent Media [EDGE DETECTION DISABLE]
Printing Hard-to-dry Media [SCAN INTERVAL OFF]
Using the Media Easy to be Winkled/Hard to be Fed [VACUUM POWER]
Speeding Up Output for Narrow Media [FULL WIDTH S]
Preventing Soiling of the Media and Dot Drop-out [PERIODIC CL.NONE]
Using Sticky Media [MEDIA RELEASE ENABLE]
Clamping the Nozzle Array to be Used (CMYKLcLm mode only) [ALTERNATION DISABLE]
Fully Utilizing Cutting Function
- Preventing Pulling of the Media with Undue Force When Performing Cutting Only [PREFEED]
- Fine-tuning the Cutting Conditions [CUT CONFIG FORCE/SPEED/OFFSET/UP-SPEED]
- Accurately Adjusting the Cutting-in Amount
- Performing Distance Correction During Cutting [CUTTING MENU CALIBRATION]
When you perform Print & Cut, be sure to set [CALIBRATION] in the [CUTTING MENU] to "0.00%." Otherwise
the printing and cutting positions may become misaligned. This calibration is to be used only when performing
cutting only.
Correcting Misalignment of the Printing and Cutting Positions
- [PRINT - CUT ADJ.] (Print & Cut Position Adjustment)
Prioritize The Suttings Setting of This Machine to The Settings of a Computer Side
- [CUTTING PRIOR]
7-11