Roland VersaCamm VS-640 Service Notes page 174

Disconnect the Ink Tubes (Head Carriage Side) from the
14
Joint Adapters, the Y Tube Joints and the Circulating Pump.
And, put the clear tape at the tip of the Ink Tube to prevent
the ink from coming out.
It is not necessary to replace the Ink Tubes (Car-
tridge Side).
Revised 3
No.1 to 6 :
1000007188 TUBE,SJ-RDG3*4 LINK6 VS-640_01
1000007210 TUBE,SJ-RDG3*4 LINK6 VS-540
1000007239 TUBE,SJ-RDG3*4 LINK6 VS-420
1000007255 TUBE,SJ-RDG3*4 LINK6 VS-300
No.7 to 10 :
1000006797 TUBE,SJ-RDG3*4 LINK4 VS-640
1000007211 TUBE,SJ-RDG3*4 LINK4 VS-540
1000007240 TUBE,SJ-RDG3*4 LINK4 VS-420
1000007256 TUBE,SJ-RDG3*4 LINK4 VS-300
Open the Wire Saddle fixing the Ink Tubes and pull up the
15
Ink Tube from No.7 to No.10 on the Support Frame.
Open the Wire Saddle fixing the Ink Tubes at the rear of the
16
Head Carriage. And pull out the Ink Tubes from the Cable
Tie and the Tube Guide.
<No.1 to 6>
<No.7 to 10>
Support Frame
Tube Guide
3-101
Wire Saddle
Wire Saddle
Cable Tie