Roland VersaCamm VS-640 Service Notes page 176

Revised 3
Confirm that No. 1 to No.10 are lined from the top to
the bottom of the Ink Tubes (Head Carriage Side).
No.1 to 6 :
1000007188 TUBE,SJ-RDG3*4 LINK6 VS-640_01
1000007210 TUBE,SJ-RDG3*4 LINK6 VS-540
1000007239 TUBE,SJ-RDG3*4 LINK6 VS-420
1000007255 TUBE,SJ-RDG3*4 LINK6 VS-300
No.7 to 10 :
1000006797 TUBE,SJ-RDG3*4 LINK4 VS-640
1000007211 TUBE,SJ-RDG3*4 LINK4 VS-540
1000007240 TUBE,SJ-RDG3*4 LINK4 VS-420
1000007256 TUBE,SJ-RDG3*4 LINK4 VS-300
Put the Ink Tubes with the Tube Guide on the Support Rail
19
Frame.
Pass the Ink Tubes through the Cable Tie at the rear of the
20
Head Carriage.
Connect the Ink Tubes to the Damper Joints and the Y Tube
21
Joints. Check which number of the Ink Tube is connected to
which Damper Joint and Y Tube Joint by referring the figure.
When you connect the Ink Tubes, the Ink Tubes
may bend. Do not use the bent Ink Tube.
<Number on the Ink Tube (Head Carriage Side)>
Tube Guide
3-103
No.1
No.2
No.3
No.4
No.5
No.6
No.7
No.8
No.9
No.10
Tube Guide
Cable Tie
Damper
Joint
Head