Delta M815-MX Series Manual page 30

features and components to your system than the essential items listed above. Verify
the state or the connection, you are done. Now ready to boot the system for the first
time. Turn on the system and follow the on-screen instructions for setup.
While the tests are running, additional messages will appear on the
screen. If you do not see anything within 30 seconds from the time you
run on the power, the system may have failed a power-on test. Recheck
your jumper setting and connections or call your retailer for assistance.
Verify that the access LED on the system is unlit before turn off the
system or ejecting the CD-ROM or floppy disk. Doing so while the
access LED is lit may damage the data being stored or the CD-ROM
or floppy disk.
When you have just turn off the system, wait at least 10 seconds be-
fore turning it back on. Immediate power cycling may cause mal-
functions or failures of the system.
POST
Powering on the system starts POST and displays its check results. If the logo is
displayed, press the <ESC> key. After a few seconds, the following message appears
at bottom left on the screen.
When the error message appears, the POST displays the result upon completion
and the system waits for a key entry. Press the <DEL> key to start the setup utility.
We recommends you print out or write down your current system
parameters. This information will be need to restore your system
after motherboard replacement, if any.
The post runs automatically when you power on the system or reset it with a keyboard
operation (Ctrl + Alt + Delete). The POST run diagnostics, initializes the system,
sets interrupt vectors, detects installed peripheral devices, and boots the operating
system (if installed).
Please continue to the next section to configure your BIOS (Basic Input Output
System) setting that allow you to view and enter system configuration data. The
30
setup utility is pre-installed on your system and ready to run.
M815-MX Series User's Manual
{ Press DEL to enter SETUP }