Delta M815-MX Series Manual page 13

Read the manual and installation notes that come with the infrared
module. The contain important information which will help you install
the component right, the first time.
USB2(J11, 12): Auxiliary USB Connector (Optional)
It provides 3 USB connections (via USB Hub) to the rear of your system case by the
USB cable assembly.
Follow the procedure below to install the USB cable assembly.
Locate the USB2 connector on the motherboard.
In the system case, remove the blanking plate for the opening in the case adjacent
to the slot you are going to use (keep the removed blanking plate for future use).
Insert the cable assembly and drive a screw through the metal bracket on the
edge of the cable assembly to secure it in place.
Plug the connector of the cable assembly into the USB2 connector on the
motherboard (select either methods to install cable assembly).
Pin
1 2
5 10
J12
Assignment Assignment Pin
1 GND
2 GND
3 USBD2P
4 USBD2N
5 +5V
2. Hardware Installation
J11
Pin
+5V 1
USBD3N 3
USBD3P 5
GND 7
GND 9
M815-MX Series User's Manual
Assignment
2 GND
4 GND
6 USBD4P
8 USBD4N
10 +5V
13