Delta M815-MX Series Manual page 25

side of the cable connector with the Pin-1 side of the device
connector. Each connector has the Pin-1 side clearly marked. The
Pin-1 side of the each ribbon cable is always marked with red stripe
on the cable.
When you start up your assembled system, an IDE hard disk drive on
the Primary IDE channel is in dentified as drive C. A second IDE
drive on the Primary IDE channel is in dentified as drive D.
CD_IN J2, J3 : Audio Connector
You can connect the audio output from your CD-ROM (or DVD) drive into the audio
input connectors (either J2 or J3) on the motherboard.
Install the FDD Drive
The motherboard has floppy disk drive interface that will support one or two floppy
2. Hardware Installation
Assignment
Pin
J3
1 CD-L
2 GND
3 GND
4 CD-R
M815-MX Series User's Manual
J2
CD-L
GND
CD-R
GND
25