Delta M815-MX Series Manual page 21

Follow the procedure below to install the front panel I/O.
Locate the FSP1 connector on the motherboard, begin connecting the front
panel switch and indicators to the appropriate pins on the FSP1 connector. Use
the illustration below to make the correct connections.
Installing Add-on Card
This motherboard has one AGP slot, two 32-bit PCI slots, and one AMR slot .
The AGP (Accelerated Graphics Port) is a PCI-based interface which was
designed specifically for demands of 3D graphics applications. The 32-bit AGP
channel directly links the graphics controller to the main memory. While the
channel run at only 66MHz, it supports data transmission during both the rising
and falling end of the clock cycle, yielding an effective speed of 133MHz.
PCI stands for Peripheral Component Interconnect. PCI is a 32-bit local bus
(data pathway) which is faster than the ISA bus. Local buses are those which
operate with in a single system (as opposed to a network bus, which connects
multiple systems).
AMR (Audion Modem Riser)/DVI (Digital Visual Interface) specification provides
a hight speed communication between your personal system and a remote
2. Hardware Installation
Pin
26 25
1, 2
5, 6
7, 8
19, 21, 23, 25
18, 20, 22
2 1
24, 26
Assignment
PW-SW
RST-SW
HD-LED
SPEAKER
PW-LED
KB-LK
M815-MX Series User's Manual
21