Delta M815-MX Series Manual page 11

J9: Wake-up On LAN Connector
This connector that used for remote wake up system through a network. If you have
install a network adapter add-on card, you can cable the card to the J9 connector. If
you enable the wake on LAN setting in the BIOS setup, incoming network traffic can
resume the system from a power-saving mode or software power down.
This feature requires that the Wake-Up by PCI card is set to enabled (see "Power
Management" under chapter 3 BIOS setup) and that your system has an ATX power
supply unit with at least 720mA/+5V standby power.
BAT1: Lithium CR2032 Battery
It is a coin-cell style Lithium CR2032 battery is used to provide power to the Realtime
Clock and CMOS memory for keep the data inviolate and effective. The Realtime
Clock which provides the data and time to the system. The CMOS memory is used
for keeping the information of the system configuration, so the system can
automatically boot-up OS every time.
The battery has a 2-3 years life if the system is not power up. When the system power
up, the power for the Realtime Clock and CMOS memory is supplied from the 3.3V
2. Hardware Installation
Jumper Setting
2
SHORT Pins 1-2
1
OPEN Pins 1-2
Function
Wake-Up Enabeld
Wake-Up Disabled
Pin Assignment
1 +5VSB
2 GND
3 Wake-Up Signal
M815-MX Series User's Manual
3
1
11