Teledyne Princeton Instruments PICam 5.x Programmer's Manual page 88

88
Table 5-23:
PicamParameter
Enumerator
PicamParameter_ModulationFrequency
PicamParameter_ModulationOutputSignal
Amplitude
PicamParameter_ModulationOutputSignal
Frequency
PicamParameter_ModulationTracking
PicamParameter_ModulationTrackingBit
Depth
PicamParameter_NondestructiveReadout
Period
PicamParameter_NormalizeOrientation
PicamParameter_OnlineReadoutRate
Calculation
PicamParameter_Orientation
PicamParameter_OutputSignal
PicamParameter_OutputSignal2
PicamParameter_PhosphorDecayDelay
PicamParameter_PhosphorDecayDelay
Resolution
PICam™ 5.x Programmer's Manual
Enumerator Definitions (Sheet 6 of 11)
Controls the frequency of the intensifier modulation in MHz.
Controls the peak-to-peak amplitude of the user RF output
signal in volts (V).
Controls the frequency of the user RF output signal in MHz
Controls the tracking of a sequential phase or custom
modulation sequence in metadata via the
PicamModulationTrackingMask
Refer to
page 81 for additional information.
Controls the size of one component in a varying sequential
modulation phase or custom modulation sequence.
NOTE: This metadata is floating point.
Controls the rate at which the hardware will non-
destructively readout during exposure in seconds (S).
NOTE: This duration must be less than exposure time for
Controls automatic orientation correction for data due to
readout ports used.
Reports the fastest possible readout rate that could occur
given the current setup and accounting for possible changes
to online hardware parameters while acquiring
Reports the orientation of the data via the
PicamOrientationMask
Refer to
for additional information.
Controls what timing signal is issued from the hardware
monitor via the
Refer to
additional information.
Controls what timing signal is issued from the second
hardware monitor via the PicamOutputSignaldata
enumeration.
Refer to
additional information.
Controls the length of time the hardware waits for the
phosphor to decay before reading out. The time unit depends
on
PicamParameter_PhosphorDecayDelay
Controls the time unit used for phosphor decay delay. This
value is in microseconds (
Example: A resolution of:
• 1 signifies delay is in microseconds (
• 1000 for milliseconds (mS);
• 0.01 for tens-of-nanoseconds (nS).
Description
Section 5.1.1.20, PicamModulationTrackingMask, on
any non-destructive readouts to occur.
data enumeration.
Section 5.1.1.21, PicamOrientationMask, on page 81
PicamOutputSignal
Section 5.1.1.22, PicamOutputSignal, on page 82 for
Section 5.1.1.22, PicamOutputSignal, on page 82 for

S).
Issue 11
data enumeration.
data enumeration.
Resolution.

S);